http://www.scribd.com/doc/3800513/Ne...-Configuration

I followed the link above to configure TheGreenBow to work with FVS318 V3 (VPN Gateway)

How can configure TheGreenBow to work with Snap Gear Sg300 instead of FVS318 V3 (VPN Gateway),,,,I tried it but i could not get it work

Hi

I have got this scenario ,,,ADSL modem Netgear router its LAN ip address 192.168.1.1 and one of its LAN port connected to a WAN port of SnapGear SG300 (192.168.1.2),,,,,,,,,,,here is my confusion during VPN setup I have to use many IPs which one should I chose (double natted) ,,,,could someone walkthrough the snapshots below to help me out if he/she finds any incorrect settings

http://www.snapgear.com/index.cfm?skey=1556

LAN ip address for SnapGear SG300 is 192.168.0.1
I tried hardly to find any online documentation , the only site that I found was below
http://quark.humbug.org.au/publicati.../msg00038.html

I did my best to configure IPSec for SnapGear SG300 as below (I could not figure out where is my mistake):
1- Tunnel settings
[/URL]
http://img196.imageshack.us/i/tunnelsettings.jpg/

2- Local Endpoint settings
[/URL]
http://img269.imageshack.us/i/locale...tsettings.jpg/

3- Remote Endpoint Settings
[/URL]
http://img689.imageshack.us/i/remote...tsettings.jpg/

4- Phase 1 Settings
[/URL]
http://img691.imageshack.us/i/phase1settings.jpg/

5- Phase 2 Settings
[/URL]
http://img4.imageshack.us/i/phase2settings.jpg/


I used TheGreenBow VPN client utility ,,,,,my configuration as below :
1- Phase1advanced
[/URL]
http://img33.imageshack.us/i/phase1advanced.jpg/

2- Phase1 Authentication
[/URL]
http://img269.imageshack.us/i/phase1authentication.jpg/

3- Phase 2
[/URL]
http://img269.imageshack.us/i/phase2b.jpg/

By looking at those snapshots I would appreciate any hint or tip where I did misconfigure although I will try to post logs for both router and TheGreenBow.
Thanks