connect modem 192.168.1.1, cant display page on internet explorer 8.

[michael]

connect model no: DB-108 TM Modem , log in 192.168.1.1 but cant display page on IE 8 it is blank.

try D-link and other brand it is work, try few unit TM DB-108 is not work.

[grr]

may be TM DB-108 interface is not supported by IE8...

[shan]

most of the guyz who i knw have d-link have problems...
i would advice u to contact the place u bought it from or some tec fellow

and it seems like ur type isnt the only one with a prob
http://forums.techguy.org/networking/864376-d-link-dir-600-a.html

[Flatlands]

Reset and start again

[LizardMan]

Try it to Firefox.

[nokiaseller]

U can try to use command prompt by typing "telnet 192.168.1.1" . If u can login by using command prompt mean u modem is ok.
TM modem can login by using telnet but for other router dont think it can do it because mostly there block port 23 not allow u to telnet by default.

[In-f3st]

First try to ping your modems IP address (in this case 192.168.1.1).
Check your cable and LAN port, maybe you're plugging it into a IPTV port or some other port (usually LAN1&2 are for Internet).
If your Lan port isn't working (indicated by the little lamp) you should try a "factory reset"
(most modems have a small reset button that you should hold for a few seconds).

Doing so you will reset your router/modem to the factory settings. This helps when ports stop working.

There is also the possibility that the IP address of you router is not 192.168.1.1 if you changed it to some other IP address.

If all this fails then you router is most likely not usable any more...